MaxJax MX-6 install

[bigdustydog]

Hi All, I'm woking on the install of a MaxJax MX-6. The hydraulic connections to the cylinder (as per instructions) seem to block the center outside bolt hole. How have other users of the MX-6 handled the installation of the hydraulic connectors?
The attached photo is from the MaxJax website, but mine looks the same. Thanks for any help (MaxJax support isn't too supportive in my effort) Click image for larger version

 

[grtpumpkin]

Mine is set up exactly like that. I will admit that I have not removed my columns since I installed them. I tightened that center bolt with a large crescent wrench. If memory serves me right I was able to swing/move the cylinder and the attached fittings aside just enough to get enough wiggle room to get the bolt in. Shouldn't really be a problem. Mine is the mx6 model. I use my lift often enough so I don't bother to take it down.