MaxJax owners...quick question

[Jason280]

I am finally setting up/laying out the holes for my MaxJax, curious if anyone has bolted one down and found it didn't quite "fit" for one of their vehicles. My plan is to use it primarily with a few Jeep YJ's/CJ's and a Mazda B2600i, but also have a 4-door Toyota Matrix and '08 Expedition.

Anyone mounted one and run into fitment issues? Thanks!

 

[Cobra96]

I set mine up for my grand caravan and just made it with my mustang. In the manual it has suggestions for distance. The best thing would to drill extra holes and install extra anchors.dont waste time with the wejit, just buy the power sert epoxy. Look up anchor co. On line, they have great deals

 

[Jason280]

Yeah, I've been pricing a few of the epoxy kits...had no idea they would be so expensive!

 

[Cobra96]

The problem with the wejits is that the hole and concrete have to be near perfect and if they don't snug up within three turns, the common mistake, I made myself is to keep turning until they tighten up. I think the manual states 3 to 3.5 turns and that's it. They set once weight is applied to the lift. The second mistake is that once the posts are bolted down is that again, the bolts are over tightened putting an overextended preload on the anchors. The bolts are meant to be tightened and then snugged down. Cal, Danmar for clarification, the are very helpful!