en2burrell
Member
Looking for a decorative metal wrap for my wooden garage columns. Any suggestions? 
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Metal garage support column wrap
- Thread starter en2burrell
- Start date
rsanter
Well-known member
I have seen stainless and aluminum diamond plate used before in stores.
you may want to think about some industrial rubber corners
bob
you may want to think about some industrial rubber corners
bob
Kevin54
MEMBER EMERITUS
Indoor/Outdoor carpet maybe?
boiler7904
Well-known member
Personally, I'd avoid using a sheet metal column wrap in a garage. You will hit it with something at some point and will be left with a dented column wrap. If you're determined to use metal, I'd go with something like aluminum diamond plate sheets and then a matching angle on the corners all attached with countersunk screws.
If there's a chance that you'll be hitting the column(s) with car doors accidentally (of course), think about using something soft. I've seen heavy rope used in a nautical-themed basement of a beach house before. Looked good and was a lot safer for little kids running around.
If there's a chance that you'll be hitting the column(s) with car doors accidentally (of course), think about using something soft. I've seen heavy rope used in a nautical-themed basement of a beach house before. Looked good and was a lot safer for little kids running around.
OP
en2burrell
Member
Thanks for all the feedback.