Metal liners on ceiling

[Dustyrhodzee]

Planning my attack in my shop.
I am going to put corrugated metal liners on my ceiling and osb and the walls. Is it best to install the ceiling first or the osb? What would you use for trim where the panels and osb meet?
Thank you

 

[Mattlt]

J-channel around the perimeter of the ceiling. I did my ceiling first. Then the OSB on the walls can **** up against the J-channel. Probably doesn't matter a whole lot.

 

[MAYOR28]

I did the walls first then the ceiling. Not sure it really made a difference one way or the other. But I did add trim to walls to cover the gaps (I didn't buy J channel...probably should have).

 

[finn]

Walls first, then screw the Chanel tothe surface of the wall to accept the ceiling sheets.

 

[NUTTSGT]

Walls first, then screw the Chanel tothe surface of the wall to accept the ceiling sheets.

This is what I did. It allowed me to screw the J-channel into the wall and not have to worry about hitting a stud every time.

 

[rburke65]

I did the ceiling first. I’m sure there are a dozen ways to do this.

 

[Milzo]

I am doing the same thing but with 1/2" plywood on the walls. The amish installed the plywood on my walls and are doing the ceiling after. They wanted the walls done first so they can screw the metal wall trim for the ceiling to the plywood. Also easier to paint the walls before the ceiling is installed.

 

[Dustyrhodzee]

Thank you very much
Cheers