Metric pulleys

[Twisted Sid]

Does anyone know of a good website where I can get v belt, metric bore pulleys from? I searched a few times for them but all I could really find were cogged timing belt pulleys with a metric bore. I need one for my belt sander/grinder project.
And no, I don't have access to a lathe to make my own.

 

[ChevyEFI]

If the metric spindle is slightly larger than the pulley i.d., you may not need a lathe.

 

[larry_g]

http://www.gates.com/~/media/Files/Gates/Industrial/Power Transmission/Manuals/2012 Catalog.pdf

Use a pulley with a taper lock hub and the appropriate hub to fit your shaft. If you would give up a bit more information on what size pulley, belt and shaft size then better answers will be had.

lg
no neat sig line

 

[Twisted Sid]

Damn, I thought I put that info in there.
The shaft is 10mm, the pulley needs to be 2.5'' dia(+/-), and the belt is a 4l260 belt. http://www.grainger.com/product/DAYTON-V-Belt-4L260
I'm still leaning about belts and pulleys sizes and all the different kinds that exist.
My belt sander works right now but it vibrates REALLY bad and makes a lot of noise. It seems to be coming from the pulley on the belt drive shaft.

 

[larry_g]

Damn, I thought I put that info in there.
The shaft is 10mm, the pulley needs to be 2.5'' dia(+/-), and the belt is a 4l260 belt. http://www.grainger.com/product/DAYTON-V-Belt-4L260
I'm still leaning about belts and pulleys sizes and all the different kinds that exist.
My belt sander works right now but it vibrates REALLY bad and makes a lot of noise. It seems to be coming from the pulley on the belt drive shaft.

So did you spend a bit of time finding what you need in the catalog I linked to? If I remember the hubs are on page 254 or there abouts.

lg
no neat sig line

 

[Twisted Sid]

I haven't had time yet. I was going to look through it later today.

 

[454ragtop]

Curious why you're using such a small shaft, seems like it would bend awful easy.
Jim

 

[Twisted Sid]

Because thats the size shaft that came on the belt sander

 

[mrborohachi]

Dayco phone app perhaps

 

[Twisted Sid]

Well, I just looked through that catalog and nothing seems to have that small of a bore. The smallest I could find was 1/2'' and 14mm bore.
So the hunt continues...