Miller Goldstar 300SS

[Jcrouch]

Good Afternoon
I'm brand new to this site seen a lot of good information here. I have a question about a Miller Goldstar 300SS welding machine. This machine is 3 phase can it be converted to single phase using the Haas-Kamp method?

And I hope I posted this in the right forum.

Thanks

 

[woody 73]

I have no clue about welders but I do know this...

This is 2020 so anything made from the year 1970 and before then you can post away your question. So just how old is your machine in question???

We have an electrical section plus we have a general tool section. But (always a but), your question will get answered in the general tool section but it will take about 18 seconds before it hits page 5, so good luck.

Hope that helps you out.

 

[Jcrouch]

Yes sir it does and thanks for the info.

 

[woody 73]

Just as a reminder to my fellow brothers and sisters please I beg you (I hate being the bad cop on the block) if you guys see a post that has nothing to do with items not being in the right section please take a few seconds and just report it.

If all of us start now (A line in the sand) then maybe we can slow down this section, enough so that the stories will stay around longer then a few hours. Because as we all know or at least most of you are aware in the General tool section nothing lasts for very long. I just don't want this to happen in the vintage tool section.

Apologize to the OP for the rant carry on good sir.