Miller matic 120

[a***nc83]

Hey guys, so since joining this forum, i have found myself developing an interest in things i never thought i would have. In saying that, i find myself longing to start welding...lolol...although i really have no need to weld anything...but i suppose that's besides the point anyways.

I looked at a few threads where people were asking similar questions...but didn't quite get what i was looking for from them...so i called around, and one of the guys suggested this...so here is my question...is the Miller Matic 120 mig welder a good starting welder? Something to learn on, and that would last me while, and fairly versatile? Oh it's a 220 v, and i have access to 220v

And if so, what can i look to pay for one?


As is always...any help is appreciated.

 

[Voi]

I am learning on a Millermatic 135 with fluxcore. I'm certainly going to buy a more powerful machine once I get a subpanel ran but I'm glad I had a chance to learn on this machine.

However the one I've been using runs on 120 not 220. Does Miller make 220v welders in the 120 class for the Canadian market?

 

[kc-steve]

The Hobart version is likely the same quality but less money, and same parts. Just sayin'.

Steve

 

[TF.120]

The MM120 is a good welder, its rated for for 150 amps so its good for smaller stuff. The duty cycle is a little low if i remember right (30% ?).

For me i would think 150-200 for one if it had some accessories like regulator and was in great condition i would go 300. You just have to remember that it is just a 150 amp machine.

 

[a***nc83]

I am learning on a Millermatic 135 with fluxcore. I'm certainly going to buy a more powerful machine once I get a subpanel ran but I'm glad I had a chance to learn on this machine.

However the one I've been using runs on 120 not 220. Does Miller make 220v welders in the 120 class for the Canadian market?

The one that the guy recommended was 220v.