Miller Spectrum 375 CutMate plasma ...

[1953mercury]

cutter. Assuming this is an older machine. Anyone have one? Any comments or experience using one? Any info much appreciated. Thanks, Mike

 

[Just_George]

Had one, and while it worked, I was 'underwhelmed' by the performance. I always felt like it was a little limited and a bit underpowered. Sold it and bought a Hypertherm - yes, they're more $$, but I really think it's a MUCH better machine. All that said, if you can find a really good deal on the Miller, it WILL work well within it's limits.

 

[zkling]

I've used one quite a bit, don't personally own one. X2 what George said. They are good machines as long as you understand their limits, but that kinda goes for any plasma or welding machine.

If I was going to purchase a new plasma I would probably go with one of the smaller hypertherm boxes.