Milwaukee Grease Gun

[plewlandsbob]

Hi , what is the thread, on the end of the hose, is it 1/8th NPT ? I can't get a replacement coupler ,locally, over here in Scotland. 1/8th BSP, is the standard fitting over here, but that is different to your 1/8th NPT

Thanks
Bob

 

[Rosso]

FYI, most air tools bought from the states use NPT threads.

I've never had an issue using PCL BSP fittings in any of them. I know the world will end and famine will strike but they screw in fine and seal even without thread tape etc.

If your dead set on getting an NPT threaded coupler though you can buy BSP to NPT adapters on the internet here in Scotland.

 

[MJD1]

NPT and BSP are entirely different. They are 1 thread per inch off in the 1/8" size. It may start, but it will not work.