You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Misc. Older Snap-On Stuff
- Thread starter kukko
- Start date
05CarbonDRZ
Well-known member
PM sent on SO 3/8" Breaker Bar
sumner52000
Well-known member
2 Blue Point Supreme wrenches:
I'll take them. Sending pm.
I'll take them. Sending pm.
CAPTTOMB
New member
By any chance have a Snap-On transmission output shaft bushing remover/installer tool?
Deafautotech
Well-known member
Long open end with swivel box end. 3/4"
marked: Snap-On OH24 USA Pat. No. 3273430
Finish is good. Minor flaking near open end jaws. This is about 18" long.
Asking $25 shipped.
i am wondering what is it for??? i am might interesting but need know what it is??
Deafautotech
Well-known member
This is just an extra long saltus wrench They were listed in the car alignment tools section in Snap on catalogs. Very handy for stubborn bolts or nuts.
thanks! it would be nice as it can work similar 19mm but closer... i do sometime has to work on import vehicles so that wrench can be handy...
Deafautotech
Well-known member
sent the pm on this Long open end with swivel box end. 3/4"
marked: Snap-On OH24 USA Pat. No. 3273430
marked: Snap-On OH24 USA Pat. No. 3273430
I can fix anything
Well-known member
Late 50's/Early 60's GM caster adjusting wrenches/torque multiplier Special Wrenches and 1 special socket.
marked: Snap-On S9834 (rectangular zero, date code 1960) USA USING TO -150 THE DESIRED READING IS 1/2 DESIRED TORQUE
Finish is decent with some small spots of rust throughout (will clean up). Has 7/8 reversible ratcheting box end (works fine). This is about 20" long.
marked: Snap-On S9837 I (1961 date code) USA USING TO -150 THE DESIRED READING IS 1/2 DESIRED TORQUE
Finish is funky. It may clean up with wire wheel, I just lightly rubbed it with some fine steel wool. This is about 20" long with 11/16" reversible ratcheting box end (works fine).
These both have 1/2" drive squares where a torque wrench fits in. These can be found in the 1960-1965(or so) catalogs seen here: http://www.collectingsnapon.com/index.html
marked: Snap-On 3/4 WA 24-28 L Pat No 3273430 This is a hollow socket that fits in the 7/8 S8934 wrench. 3/4" 12 point.
These are special tools, heavy, long.
Asking price for the wrenches and socket is $40 PLUS shipping costs. More pics available upon request.
Interested, is there a date code? price shipped to 75418?