Model M Hein Werner handle to chassis shouldered spacers needed.

[an8pilot]

I found this jack in Boston and brought it home near JAX.

It is missing the two shouldered spacers needed that go between the bottom of the handle where it pins into chassis.

Part M516 and M521

In picture below.

Without them the handle bar side pins are sloppy in the chassis by about 1/8 to 3/16.

Would be great if I could find them.

Just two spacers with a machined flange that fit over the side pins and into the bigger holes where the pins insert on each side.

 

[Cruzan80]

I may be able to get measurements off of mine. That is, if I can ever get the stupid pins out in the first place...

 

[The Cobbler]

your diagram shows m516 as a handle stop and 2 required for m521 handle busing.
your post suggests you just need the handle bushings.

 

[an8pilot]

Yes Cobbler you are right thank you. I didn't decipher the diagram and 2 required correctly.

So then I need just the two M521 unless I can figure out what to piece together out of bushings and spacers I have laying around in the shop.