Here is a welding/fab table I made that I can convert to a motorcycle table. I made it so I can install these inserts in the end like a hitch reciever when I want to use it as a motorcycle table. Each corner has them too for adding attachments to the table like a vise.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
motorcycle/welding/fab table I made
- Thread starter jagxl1
- Start date
OccupantRJ
Well-known member
Nice! Good dual use of a shop item. The smaller the shop, the more important that is. You might also want to post this in the fabrication section.
Zeke
Well-known member
Wow, 6 different positions for accessories. Best table yet.
rasit
Well-known member
Nice! Is that an Ironhead?
Yes, it is a 1972.Nice! Is that an Ironhead?
bad_idea
Well-known member
i would guess the chain fall and straps that it's hung from in the last pic. i would like to see pics of the fall. nice table. how well do the wheels roll? i have a set of hf car dollies with what look like the same wheels, they ****!
I use a 1 ton chainfall that is strung across 2 2x4's that are strung over 3 cieling joists. definately more that enough to handle the 400 lb load. The bike is well secured to the table and the casters roll good with the bike on the table. The casters came off a 1500lb rated heavy duty trans jack. I definately wouldnt put my bike up there if i wasnt sure it would hold more than twice it's weight.
Hammer1963
Well-known member
Really nice job on the table. I like how you have made the table versatile by having threaded areas to mount other pieces on to it. A really clean design