Mounting side locker on KRA 2422

[Ram Hemi]

Thinking about adding a full height side locker to the side of my kra 2422, not a snap on side locker though, can't justify 3k for a locker to hold bulk stuff. My question is regarding mounting it, how does the snappy one mount or how have other people mounted them? There are 4 holes with rivi nuts forountinf the handle too they look to be 5/16", are these alone strong enough for a couple hundred pounds? NOTE I have the stainless too so there is basically no lip to hang it off of because the too is nearly flush all the way around. I won't be drilling extra holes in the box, I would be open to driving holes in the locker though. If anyone has a side locker snappy or other on a snappy box it would be grat to hear what you have done

 

[Fcvapor05]

All snap-on lockers mount the same way- there's a lip on the locker or drawer section that hangs the locker on the top lip of the box, and then bolts through the handle holes.

If the locker you buy doesn't have this lip, and you don't want to add holes to the box, you'll have to make a sheet metal adapter. Should be too hard. Bend the lip at the top, drill the sheet metal plate for flat head screws so it will lay flush against the side of the box, leave thru holes for the handle bolts to hold it all together.

 

[Ram Hemi]

I was thinking of mounting a small piece of angle the length of the locker so it sits fairly tight on the top of the stainless top and bolts to the side of the locker, that would hold some weight, especially as I wheel the box around.