my work box

[nikh]

Hello everybody, I've been meaning to post this for a while now, but procrastination has gotten the better of me. So here we go. It's a 56" Montezuma (Made in Canada by Quality Craft) with a Kennedy 3611 on top, and a 26" Craftsman 5 drawer cabinet bolted to the end. The top is a 60" x 30" x 2" maple counter top I ordered on ebay, with a 14" x 5" maple jawed vice I made. The tool selection is mostly geared toward aircraft structural repair, but once you start a collection like this, it tends to get a bit out of hand. I'll post more photos as time permits.
And feel free to ask questions about any of it, there are some oddball tools in there, some dating back to times before powered flight.

 

[Tundra]

I like that setup.

 

[jeffmoss26]

Nice setup!

 

[Mustang1167]

That is a Frankenstein box. I like it!

 

[nikh]

More...

 

[nikh]

Thanks, this is about four years worth of collecting. I started out with pretty much just the SO set that I had to buy for A and P school.

 

[TBrian]

Nice setup! I like that!

I have one of those:
http://www.sortimo-shop.us/category-s/121.htm
It's good to organize my power tools and screws etc. Not as professional as yours but pretty neat

 

[Chris_the_wrench]

How tall is the drawer with the plier rack and hammers?


Sent from my iPad using Tapatalk

 

[nikh]

I want to say that it is around 4-5" deep, the big dead blow was too tall to get shadowed in vertically. If you would like I can get a hard measurement on it tomorrow.