To avoid these ads, REGISTER NOW!

Name this tool(Or whatever it is)

bigbubba

Well-known member
Joined
Jul 12, 2010
Messages
2,884
Location
Poplar Bluff Mo
I bought a cheap plastic tool box at a flea-market this weekend for $3 that was full of tools,Most were junk but i bought it because there were 5 hammers in the box! 1 small dead blow 1 small rubber mallet 2 craftsmen claw hammers and a small ball peen. Any way this was in the bottom of the box.
newtool4.jpg

newtool3.jpg

newtool2.jpg

newtool1.jpg

I have seen one before just cannot remember where or what it was used for.
 
To avoid these ads, REGISTER NOW!

venturesomerite

Well-known member
Joined
Nov 3, 2011
Messages
1,135
Location
Connecticut - not sure why though...
No idea what it's for, but what it looks like to me is a tool where you put the end say under an appliance and push down on the longer handle side so that it uses the bend as a fulcrum and moves the appliance up so work on or get on a dolly or something.
 

rockchucker

Well-known member
Joined
Mar 27, 2010
Messages
1,764
Location
Seattle WA
Tire Spoon?

I agree on the possibility of it being used as a Fulcrum Point for lifting something.

Need better pics of the Fulcrum end. Looks like it is missing a handle or something that goes on the end there.


Take a picture of it with a Tape measure next to it to give an idea of how big it is too. From the pics you can't tell if it is a few feet or a few inches.
 
OP
B

bigbubba

Well-known member
Joined
Jul 12, 2010
Messages
2,884
Location
Poplar Bluff Mo
Sorry for the cell pic's,The camera's cord broke so thats the only way to get a pic.It is about 18" and the folcrum end looks to me like it will fit into something.I'll try and get a better pic later.
 
To avoid these ads, REGISTER NOW!
To avoid these ads, REGISTER NOW!
Top Bottom