Need a Vice Jaw

[justatool]

I recently picked up an old but very good condition Record vice. Unfortunately it is missing a jaw. This is a small number 0 vice.

Looking at Irwin's website they list jaws for this but unfortunately they are no longer available. Any one have any ideas where I might source one of these.

 

[lilredex]

You could just make one from suitably sized bar stock. Good enough for day to day general work.

 

[PCO6]

I've purchased Record hard and soft vice jaw sets with screws at Acklands-Grainger in Canada (not sure where you're from). They're usually in the $30 to $40 range based on size.

 

[jeffmoss26]

Could someone move this to General Tool discussion?

 

[collision1]

I have many vices, but I don't know what a vice jaw might be.

 

[PCO6]

^^^ - Many countries spell vice with a "c". The U.S. spells it with an "s".

 

[87bob]

I don't remember the name but, there is a company in Grand Rapids Michigan that makes or sells vises. My Sears vise broke a jaw, I did a internet search and found the company.

 

[Miller6386]

I don't remember the name but, there is a company in Grand Rapids Michigan that makes or sells vises. My Sears vise broke a jaw, I did a internet search and found the company.

Are you sure it wasn't Fake Arbor in Grand Haven Michigan? They mainly make presses but I believe dabble in vises also.

Telecommunicated