Need handle for a 8" Samchully machinist Vise

[ClassicCannons]

Here a vice i bought when i was in California Visiting my EX it was on ebay for 0.99 cents and i knew why after i won. I had drove to the sellers shop and boy was this heavy. It was a hell of a job taking it on the train back to Kansas. I knew if i checked it as luggage i would be charged so i used a rolling suitcase. But still it was a hell of a job not letting the conductor know because of there so called weight limit with carry on also.

This thing had to weigh over 100 lbs. Long sroty short the handle broke going up the steps carry it with one hand.

Well it was worth it fits great on my Bridgeport.

Has little to no gap nor does it allow lifting when tighten. Had to remove the swivel. Really don't use it Got a poland indexer.

Size is 8" wide by 2.250 deep and opens to 6"

Also does any one know where i can get a handle i lost the one it had back in Cally

Thanks Austin

 

[nine4gmc]

You ****!!!!

 

[PT Doc]

A standard Kurt vise handle wont work?

 

[larry_g]

What is the distance across the flats? Is it square or hex?

http://www.kurtworkholding.com/accessories/vise_handles.php

Click on these handles above and you will see the different hex sizes Kurt uses.

lg
no neat sig line

 

[ClassicCannons]

What is the distance across the flats? Is it square or hex?

http://www.kurtworkholding.com/accessories/vise_handles.php

Click on these handles above and you will see the different hex sizes Kurt uses.

lg
no neat sig line

Hi
The flats are .858

but the 7/8 boxed end wrench works fine

Thanks Austin