Need help identifying Atlas drill press

[Brianm77]

I have an old atlas drill press that I need to get a few parts for so I can put back in service. I can't seem to find a model number. Mainly I need a quill pulley. The shaft is splined along with the pulley, I have not been able to find another one like it. In the reading that I have done seems the fact that it has a 3 spoke feed handle is important.

Sorry for the poor pictures, I did not want to drag it out of the hole it has been in to take pics.

If some one could point to were to look or what to look for that would be a big help.

 

[tailshaft56]

Clausing picked up the Atlas line. I was able to gear for my lathe. Be prepared for sticker shock. If the spline is good you may be able to turn down the pulley. bor a new pully to accept the spline and weld or Locktight it in.

 

[Brianm77]

The pulley is warped. I was hoping I could come about a model number. Then find a parts book and start shopping around.

 

[tailshaft56]

Just call Clausing. They should be able to look it up.

 

[mikegt4]

That looks like a 6(x) or 7(x) model 15" drill press, probably 1940's era. Look at the photos in the link for a better ID.
http://vintagemachinery.org/mfgindex/detail.aspx?id=51&tab=4

 

[Tom99]

Brian, I might have the pulley you need. Atlas also made craftsman presses. I parted out the craftsman 15" press shown below and still have a few parts left. I can get some measurements if you are interested.

Tom

 

[Brianm77]

Tom, I am very interested. Yes please on the measurements. May also be interested in the quill lock mechanism if you still have it.

 

[Tom99]

Yes, I still have the quill lock. I'll get some measurements for you in the morning.

 

[Tom99]

PM sent

 

[Franklin]

This is my first time on this thread. I am trying to locate a depth gauge and a quill cover, and a motor mount for an old atlas drill press that doesn't have a model # or serial#. I believe it to be a 6 or 7 model. It has three handles on the quill depth control, the swept top housing. If anyone can help me find these parts your assistance would be appreciated. the part number on the speed reduction pully assembly is W15-1. Can some parts on these old machines be interchanged, such as the depth gauge and the engine mounts?