Need help to identify this......

[daddy2coull]

I really don't know why i bought this (ok, i do know, it's got an orange handle) now I have it, I really don't have a clue what it's for haha

any of you guys know?

 

[daddy2coull]

I forgot to say it's a YA893O

 

[RPH]

It's a snap-on!

 

[MFolks]

It looks to me, like it will take any 1/4" hex screwdriver bits, allowing for greater torque in tight places. I've got a cheaper version in my toolbox for things like this.

 

[daddy2coull]

It's not 1/4 drive. I would estimate it as 3/8?

 

[jjjrmx5]

Ratcheting 30 degree angle 1/4" bit holder in orange hard handle.

Comes in handy as does the flat and the -30 degree angle units.

Good to have when ya need it.

 

[zkling]

Exactly 40 minutes and you had an answer. Got to love this forum and the broad collective know it contains.

 

[daddy2coull]

Trouble is, it's the wrong answer. If you read up it's NOT 1/4 drive. If it was I wouldn't have needed to ask lol

 

[zkling]

Trouble is, it's the wrong answer. If you read up it's NOT 1/4 drive. If it was I wouldn't have needed to ask lol

That is what i get for assuming something that I didn't double check first. Let me look into it.


EDIT,
OK, I think I figured it out, called a "Brake Caliper Guide Pin Ratchet " quite a few makers make them and they all look the same. Hum, that sounds kinda handy.
Hope that helps

 

[canuckian]

yep, they're a caliper pin ratchet and they also make a great bit ratchet. they take 5/16 hex bits. Mine also came with a magnetic extension.

 

[ChevyEFI]

It's not 1/4 drive. I would estimate it as 3/8?

yep, they're a caliper pin ratchet and they also make a great bit ratchet. they take 5/16 hex bits.

Interesting. I kind of wish 5/16" bits were more prevalent.

 

[canuckian]

Interesting. I kind of wish 5/16" bits were more prevalent.

they're not popular, that's for sure. I've picked up a few that came from hand impact sets and a couple other types of bit ratchet sets.