Need some advice

[dink]

In a couple months my wife and I will be moving into a house

I am going to make a screwdriver holder that is going to be mounted onto the wall.....it will be made out of wood

Here is the question part:

On the holes I want to put like a metal sleeve into the hole(this would be nice but not a must) and have like a metal washer on top of the wood basically to keep the wood from scratching everytime the screwdriver is taken out and put back in.

How would I go about mounting the metal washers to the wood? without drilling holes into them and screwing them into the wood?

 

[972500]

alittle JB weld or some sort of glue

 

[BowtieNut]

Or if you can find the right size bit, countersink them into the wood as a press-fit??

 

[dink]

Yea I was thinking about doing that.....finding the right size bit defently isnt a problem

 

[l_bilyk]

I would use a forstner bit to countersink the washers, and glue them in with epoxy

 

[Bradley Miller]

+1 on the forstner bit / epoxy route . . . sounds like best idea to me.