To avoid these ads, REGISTER NOW!

NEOGARD Urethane any good

To avoid these ads, REGISTER NOW!
To avoid these ads, REGISTER NOW!
OP
U

UCUDANT

Member
Joined
Jul 21, 2005
Messages
14
Location
Las Vegas NV, AlB NM
I was told to roll this stuff on and use two coats. One coat spinkled with sand for non skid (I preffer a smooth finish but don't want to slip if it ever gets wet) and a top coat


Luckydevil its a standard 3 car garage but my Buddy hooked me up with more than I needed :bowdown:

ZRWON can you post the link?

I was also told to seal the cracks if the they are larger than 1/8th bulider says no need to grind out the cracks just remove loose stuff. My Buddy says to grind the cracks. What's right? I think the grinder will remove all lose stuff and provide a good working surface.

Hair line... cracks ignore them?
 
To avoid these ads, REGISTER NOW!
Top Bottom