New help with Mohawk system I hydraulic lines

[Crock]

Hello

I bought a used Mohawk system I two post lift. I sent the cylinders out for rebuild and when they came back, all of the fittings were removed. The slave
side is easy to figure out, but the main cylinder has three ports at the bottom.
One is for plug,feed line and output to the slave. I am not sure if it matters which one goes where or if it’s all the same cavity inside. Does anyone have one of these lifts the could have a look how their’s is plumbed?

Thank you!

 

[Spencer Was Here]

Does this help?

 

[Spencer Was Here]

Instead of scanning individual pages from my manual, I looked online and found a PDF copy of the manual here:

http://www.mohawklifts.com/library/manuals/system1a.pdf

Hope this helps.

 

[Crock]

Thanks Spencer.

Mine doesn’t have a divirter valve and two lines overhead. Mine is the earlier version with one line connecting the two cylinders. I added some pics of the bottom of the cylinder...it might have a divirter valve built in. The first one has the fitting on it, but not sure if they are in the right spot. The other pictures are of what I see with the fittings out. Each hole is different...so it looks like it does matter which one goes where.

 

[georgiadave]

Mohawk has a line to call for advice.

 

[matt_i]

Here is where you go immediately back to the rebuild shop, figure out who rebuilt yours and ask firmly for the fittings back. They're probably laying around somewhere, strike while the memory is fresh.

 

[Crock]

Here is where you go immediately back to the rebuild shop, figure out who rebuilt yours and ask firmly for the fittings back. They're probably laying around somewhere, strike while the memory is fresh.

Thanks guys.

I do have the fittings,but don’t know which one went where.
I will have to hold off until Monday and call Mohawk.

 

[JamesW84]

Just a piece of advice: take pictures of stuff with your cell phone before you remove/take it apart.