New hot rod shop

[chop job]

Been working hard on completing the shop before winter comes. The new heater just arrived today. Here are some pictures of the work I did all the work myself so far.

 

[1/2 Cup]

Looking fantastic chop job there is nothing more satisfying than DYI.

Keep us updated..

 

[xtremek]

Nice looking place and some sweet rides.

 

[chop job]

My new heater is here now all I have to do is mount.

 

[BuickFarmer]

Love the wall and ceiling boards, what is it. Great job so far, look forward to following.

 

[chop job]

Lots of 1x8 x6 planks only thing that would fit in my car.

 

[BuickFarmer]

Whatever it takes

a lil early nailhead would look good in that rod don't ya know...

 

[chop job]

My brother came over today and we had fun putting up the heater next comes the exhaust and then the gas man and then heat.

 

[chop job]

One more picture.

 

[Iroc-Z]

Is that just tongue and groove pine?

 

[Bib Overalls]

Assume you put a lot of insulation behind and above those doors. I have only been in Wisconsin once in my life. It was winter and damn cold. I can not imagine working on much of anything in your winter season cold.

I'm a hot rodder as well and I wish I could keep my shop as nice and tidy. Keep the pictures coming. We like pictures.

 

[chop job]

Not much but it's close to the end. Cut hole this morning. 60 mph winds so not a good day to be on ladder to cut outside hole. Monday gas will be hooked up and ready to start up. Will post more pictures as work goes on.

 

[BDAZSVT]

Shop looks great. I like the natural wood walls and ceiling.

 

[Richard Cranium]

nice looking shop so far, keep the pictures coming.
Also love the rides.

 

[chop job]

To day my brother and I installed the exhaust it was 55 degrees out so was a nice day to work outside. Next we will run the wire for the Thermostat and the electric. Monday the gas man is coming.

 

[chop job]

Forgot the pictures.

 

[chop job]

The heat is on and it 60 in Wisconsin right now. The gas man did a fantastic job.

 

[chop job]

Working in my nice new warm shop. My project is a 1928 Ford sedan. I has a 49 Ford flat head motor. The chassis is from Midwest Fabrication here in Wisconsin .

 

[vonhef]

Looks great man.... And I like the street rod project ! [emoji106]


Sent from my iPhone using Tapatalk

 

[1949 caddyman]

Nice job, did you put any finish on the 1x6 walls?

 

[chop job]

No I'm going to let it weather naturally.