New install question for a newbie.

[gnab2]

How does the SPGX tinted tan look and does it hold up good to general use? I have a new install and I am looking for a cheap but durable protectant. I was looking at paint/poxy but found something on SPGX tint able coating and it confused me more in my choice. I have a 30x59 shop and a 26x41 garage, I would be doing the floors in. With that much floor I need to go as cheap as possible but durable. I am not not a cheap a$& but just very frugal.

Thanks in advance.




Sent from my iPad using Tapatalk

 

[tncatadjuster]

91 views no response does that tell you something. I can tell you that you get what you pay for with epoxy coatings.

 

[gnab2]

I was more looking for input since I have no experience in this area. I have been eyeing SW Tile Clad too.

 

[nyepoxyguy]

What's your budget and how much are the products you're looking to buy? From my experience most industrial epoxies sell for $50/gallon but its not uncommon to see them changing hands for as low as $25/gallon.

 

[LegacyIndustrial]

91 views no response does that tell you something. I can tell you that you get what you pay for with epoxy coatings.

 

[gnab2]

Thanks for the input. I have time, so I will just see what turns up. The wife wants the house garage done to so that is almost 3000sqft of flooring to do. Price is coming into play now.

Sent from my XT1585 using Tapatalk

 

[SunsetsAndFriends]

...

 

[LegacyIndustrial]

I used an industrial, surface tolerant epoxy on my floor, which has turned out very nice. I paid $55 per gallon. Now, while I purchased some of my products from vendors who frequent this site (Scotty of Legacy Industrial sold me Xtreme-set 100 and a 7" Diamabrush/shroud.), my epoxy was purchased from another supplier. From my experience, getting top technical/installer support is a huge asset. For example, I called Scotty because I wanted to use the Xtreme-set to fix a blemish that I discovered after applying my primer coat. He was super helpful. Scotty has installer experience, as well as, general technical knowledge. If I had to do it again, I would look very closely at getting my epoxy from him also.

That is might damn nice of you to say!! Thank you!

 

[SunsetsAndFriends]

...