I posted a previous topic on restoring a craftsman Toolbox, I need to figure out removing those drawers, I did get some good suggestions and some helpful photos, thanks so much. I was asked to post a picture or two so I thought i would just nip it in the bud and post what I have so far....
Current restore project where I am trying to remove the drawers
Wall hanging toolbox that I am going to keep original, obviously in use
Older Snap-On cabinet just wiped down and did a simple clean up.
Craftsman Machinist chest, keeping in original condition
Kennedy Tool "Tower" in use,not too old!!
Even though this has a craftsman badge, it was put on by the previous owner, because of the small 2" or so discolored oval under the badge, I think it might be a Gershner, not sure though, could not find any other markings.
Lastly an old Dunlap machinist Chest, did an exterior repaint, and a pretty poor job of it, this was my first attempt to clean up a toolbox, I left the drawers original.
Thanks again for the help on my previous post, I look forward to many more posts, glad I found this site!!
Current restore project where I am trying to remove the drawers
Wall hanging toolbox that I am going to keep original, obviously in use
Older Snap-On cabinet just wiped down and did a simple clean up.
Craftsman Machinist chest, keeping in original condition
Kennedy Tool "Tower" in use,not too old!!
Even though this has a craftsman badge, it was put on by the previous owner, because of the small 2" or so discolored oval under the badge, I think it might be a Gershner, not sure though, could not find any other markings.
Lastly an old Dunlap machinist Chest, did an exterior repaint, and a pretty poor job of it, this was my first attempt to clean up a toolbox, I left the drawers original.
Thanks again for the help on my previous post, I look forward to many more posts, glad I found this site!!
