Newb first post question

[REVRobert]

I created my first post yesterday evening (ET) in the Vintage Tool forum and saw that it was on hold to reviewed by a moderator (completely understand why with all the junk we get theses days).

Where can I find the on hold post? I looked in my profile, but don't see anything.

Thanks!

 

[Notgrownup]

Under find threads then your threads

 

[REVRobert]

Thanks NGU - unfortunately it is not there. Since it was under review I presumed (we all know what the does) I had submitted the post properly. Happy to create it again, but didn't want to double post. Any ideas?

 

[mike93lx]

This?

Vintage Craftsman drill press journey has started

I started looking a drill presses, both table top and floor standing, to see what was out there. I didn't want cheap imports. I wanted made in the USA. BUT soon realized that for my non-commercial use I wasn't looking to spend the dollars required to buy a quality new USA made one. Started...

www.garagejournal.com

 

[REVRobert]

YES. Thank you very much. It is now showing up under the Find Threads.

 

[NUTTSGT]

You may not be able to see it if it is not approved. It appears that it has been approved and visible currently on the first page of the section.