Offset Screwdrivers

[Provincial]

I picked up a couple of offset screwdrivers recently. They seem to be new, and were covered with old hard cosmoline. They are marked "P I made in US", although the stamping is faint and I could be mistaken. I have the impression that they were made for the military, but I could be mistaken about that, too.

I really like the design. Four different angles. Hollow-ground blades, too!

 

[Username already in use]

How long are they? Could they be marked D-I for Duro - Indestro?

 

[Provincial]

5-1/4" center to center length. Blades are 5/64" thick and 3/8" wide.

The stamping is definately a "P" because I can clearly see the vertical bar extends below the loop on the P.

Upon further inspection, the marking is "P I.CO.MADE U.S.A." The marking is poor because they used a stamp made for a flat surface to stamp the round handle of the tool.

 

[Provincial]

Anyone?