Oil cleanup

[aalleexx]

Advise needed.
Spilled oil for nail-gun on ground concrete floor, maybe 10 drops by accident. Looking for best way to clean it in prep for epoxy coating coming up. Concrete soaked up spill quickly, can barely see where it happened, but am afraid it will cause problems when coating. Looking for suggestions to prep that area. Thanks in advance.

 

[rburke65]

If there is no puddle now, I'd rub on some oil dry, cat liter, powered detergent and see if that might wick some residual oil. I'm sure the floor gurus will chime in soon.

 

[Garage Flooring]

If there is no puddle now, I'd rub on some oil dry, cat liter, powered detergent and see if that might wick some residual oil. I'm sure the floor gurus will chime in soon.

After you asorb whats there use some pour n restore to pull the rest out

 

[LegacyIndustrial]

If grinding, it will get ground out.

 

[aalleexx]

Thanks for the replies. Already ground, will try the pour n restore.

 

[rburke65]

From where....whom.....is the 'pour n restore' available? Thx

 

[aalleexx]

Amazon or Home Depot both have it.

 

[PWC Repair]

How about trying a steam vac? I would think the heat and slightly soapy solution should pull it right out of the pores??