Old belt-driven grinder bearing question

[easton65]

I have an old belt-driven grinder, made almost from scratch by my great-grandpa. Of course, the bearings are shot. The bearings have a lip on either side and are held in by these 2 metal brackets. One was held in by JBweld. My question is, can I take the shaft collar (bottom left of picture) and put one on either side of the new bearings to keep them in place? The bearings are RF102214PP.

 

[The Cobbler]

looks like they are flange bearings so you would only need a collar on the one side ( of each bearing)

 

[easton65]

True, I'm going by Tractor Supply tomorrow to get some collars. Also, the model bearing I was looking at was about $20 a piece! I ended up ordering some alternative bearings with the same dimensions, should be here later this week.