Old Black and Decker table saw belt.

[warren57]

Tried posting in other areas on the site with no luck, so decided to try here.
I acquired an old Black and Decker table saw. A 1980's model 1732.
It uses a toothed drive belt.
Have the instruction manual, but there is no parts list in it and would like to get a spare belt.
Anyone have an idea of how to find a belt?
Thanks

 

[Boilerhouse]

Try this link, part lists are shown. It appears many are no longer available but the belt is shown as pt # 451074-00. Otherwise you could take the belt to a belt shop and they should be able to match it up.

http://servicenet.blackanddecker.com/Products/Detail/1732

 

[KenC]

Measure the belt and search for cog belt, toothed belt etc. There are several sources online. I'll bet B&D used a stock belt.

 

[James-W]

If you find you cannot get a belt for it, perhaps you could replace the pulleys and use a regular "V" belt. That would not be the greatest idea in the world, but at least the saw would work.

 

[RocketScott]

Go to the nearest Motion Industries with the belt. They can match it up.

Hitachi wanted over $70 for an air compressor belt. MI was $27 for the exact same belt.


Sent from my iPhone using Tapatalk