I picked up an older speedaire 60 gallon compressor a couple of months... The 1 HP motor runs on either 110 or 220, but currently wired for 220 (top section of drawing)..
I am switching it to 110 as I only have 110 in my garage. My question though is with regard to the capacitors. Previously the T8 wire (capped together with T9 on one end, terminated at one capacitor). The same held true for T7, capped at T6 and terminated at the capacitor).
Do I still terminate T7 and T8 at the original capacitors (one left, one right) while joining them with T9?
Are the capacitors even necessary? Any help is appreciated.
I am switching it to 110 as I only have 110 in my garage. My question though is with regard to the capacitors. Previously the T8 wire (capped together with T9 on one end, terminated at one capacitor). The same held true for T7, capped at T6 and terminated at the capacitor).
Do I still terminate T7 and T8 at the original capacitors (one left, one right) while joining them with T9?
Are the capacitors even necessary? Any help is appreciated.
