On The Cheap

[lardy1]

I needed a mobile work station so I built this entirely out of material and hardware I had around the place. I bought the carriage bolts that support the caster assembly, two drawer pulls that aren't in these pics and a few self tappers for the skirt. All total I had to spend about another $25.00 to turn it into something useful. A flip up end with a cheap vise attached is in the planning.

 

[Jayman17]

Nice job, I like the wood top and the size of it.

Jay

 

[FANTM58]

Looks great !
It’s win win when you can build something from scrap !!

 

[NUTTSGT]

Looking good. It looks like you can work from either side but the drawers only come out from one side ?

 

[Motorman55]

Nice job.....Why Harley-Davidson colors?.....

 

[lardy1]

Most of my shop is orange and black. I build my own benches & cabinets and paint them.

The mobile work bench is going to be dual purpose. I'm going to make a plastic laminated, slip on top that will match the height of my table saw. It will be an infeed table or material support for sheet stock. I already built a 4X6 outfeed table on locking casters with four very deep drawers for all my table saw accessories.

Retirement is great.

 

[Jayman17]

Most of my shop is orange and black. I build my own benches & cabinets and paint them.

The mobile work bench is going to be dual purpose. I'm going to make a plastic laminated, slip on top that will match the height of my table saw. It will be an infeed table or material support for sheet stock. I already built a 4X6 outfeed table on locking casters with four very deep drawers for all my table saw accessories.

Retirement is great.

I'll be able to verify that last statement in 6 months
Good idea on being able to use as an infeed table too.

Jay

 

[Motorman55]

Most of my shop is orange and black. I build my own benches & cabinets and paint them.

The mobile work bench is going to be dual purpose. I'm going to make a plastic laminated, slip on top that will match the height of my table saw. It will be an infeed table or material support for sheet stock. I already built a 4X6 outfeed table on locking casters with four very deep drawers for all my table saw accessories.

Retirement is great.

Cool...I'm all for the Orange and Black.

And yes retirement is great. Only there still seems to never be enough time to get everything done on the weekend...oh wait that's right I have all the following week and weekend to catch up...and the next....and the next

 

[2oolhound]

Nice! You can never have enough flat surfaces in the shop.

 

[captain14]

I like it. Especially since you repurposed lots Of the material used.

Please post photos of the finished bench after the folding vise is installed please.

Thanks