Other bridge jack options for bendpak hd9st

[camaro0991]

Hey all, other than the RJ45 bridge jack availible from bendpak, what other options will work? I saw one from gregg smith that might fit, was seeing if anyone else had seen any other options? I like the rj45, but i dont have an air compressor strong enough to run it. ( My little one runs the lift locks, but a bridge jack might overwhelm it. Thanks!

 

[rsanter]

how much are you going to us it
you could operate off a nitrogen tank

bob

 

[camaro0991]

nah id like to avoid having nitrogen around. I saw a hydraulic model on gregg smith equipment. Was wondering if anyone had used them before?

 

[camaro0991]

no ones tried this?? I find that hard to believe.

 

[Junkman]

About 5 years ago, I purchased a Gregg Smith rolling jack to use on my BendPak HD9. They said it would work, but it didn't. I don't know why BendPak doesn't offer a manual jack, but it might be a good question to ask them. The BendPak and the Greg Smith units look similar, but similar isn't close enough to work.