
And if you use a 100 watt incandescent bulb you can make an Easy Bake Oven.. Made several on jobsites.Fortunately I have an attached garage so this is no longer an issue for me.
I have used this in the past - you need to do it in an enclosed area - it's not big enough to heat an entire garage.
This is a "design" I found in a "Popular Mechanics" magazine in the early 60's:
take an empty two-or-three-pound coffee can. cut a hole in the bottom. drill a whole mess of little holes all over the can.
mount a porcelain light bulb socket in the inside of the empty can. mount the can to the side wall of your enclosure. use a 15W or 25W bulb (depending upon the space you want to heat.)
the holes in the can will allow the heat to radiate through the enclosure and allow enough air movement that it won't catch on fire.
cheap. easy. works.
OR you can go to an RV supply house and buy something quite similar - my buddy has one for his motor home he uses to keep the plumbing from freezing up. It's a fairly flat unit - about 4 inches tall and about 14 inches in diameter - plastic housing.
tester19 said:You will be surprised at the age of some of the cans on your shelf!

Good luck finding those bulbs.And if you use a 100 watt incandescent bulb you can make an Easy Bake Oven.. Made several on jobsites.
Rough service bulbs are still incandescent. You may not find them at the local big box store but there still forsale.Good luck finding those bulbs.
Not the 100w version.Rough service bulbs are still incandescent. You may not find them at the local big box store but there still forsale.
Good luck finding those bulbs.
Use a similar setup around here for a fridge in the garage to keep the fridge compressor kicking on and the freezer frozen when it gets to single digits or lower. Run the cord through the door and point the bulb (set on a timer) at the thermostat.Fortunately I have an attached garage so this is no longer an issue for me.
I have used this in the past - you need to do it in an enclosed area - it's not big enough to heat an entire garage.
This is a "design" I found in a "Popular Mechanics" magazine in the early 60's:
take an empty two-or-three-pound coffee can. cut a hole in the bottom. drill a whole mess of little holes all over the can.
mount a porcelain light bulb socket in the inside of the empty can. mount the can to the side wall of your enclosure. use a 15W or 25W bulb (depending upon the space you want to heat.)
the holes in the can will allow the heat to radiate through the enclosure and allow enough air movement that it won't catch on fire.
cheap. easy. works.
OR you can go to an RV supply house and buy something quite similar - my buddy has one for his motor home he uses to keep the plumbing from freezing up. It's a fairly flat unit - about 4 inches tall and about 14 inches in diameter - plastic housing.
I was wondering where you could find a coffee can these days.
My favorite, and yea, the metal cans do come in handy. Always keep a few empties on the shelf.Huh. I thought they were banned now...Does $2 each for a 6pack work?
Huh. I thought they were banned now...
The ones in the link are rough service. They are exempt.Huh. I thought they were banned now...
Cold weather won't hurt the paint as long as it isn't latex. I leave spray cans in my garage all the time and they work just fine after below zero temps, just warm them up before using.
