You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
parts washer pump
- Thread starter bluejean
- Start date
creativecars
Well-known member
This is one for a black bull parts washer.
Recirculates 4.4 GPM of solvent
Submersible use only
120 Volts/60 Hertz 0.23 Ampere
Replacement pump
Works with 40 gallon parts washer
https://www.amazon.com/dp/B003TXYJB6/?tag=atomicindus08-20
Recirculates 4.4 GPM of solvent
Submersible use only
120 Volts/60 Hertz 0.23 Ampere
Replacement pump
Works with 40 gallon parts washer
https://www.amazon.com/dp/B003TXYJB6/?tag=atomicindus08-20
Richard Cranium
Well-known member
The one cars posted is a good one to use.
Al Bundy
Well-known member
Just bought a Little Giant from Zoro, but I haven't installed it yet. It's a lot heavier than I expected and seems well made. I paid $55 with a coupon.
When I built my parts washer I took a look at the one on my freind's Safety Klean washer at his auto repair shop. It was a Little Giant. I got the sme pump and it is still working many years later. Plenty of volume. As I recall there was a threaded fitting where the power cord came out of the pump and they connected pipe to it to hang the pump and keep the cord out of the solvent. I had to cut off the plug to feed it through the pipe and then install another plug. Other than that, no problems.
Sent from my SM-G900V using Tapatalk
Sent from my SM-G900V using Tapatalk
foghorn1966
Well-known member
1-YS Little Giant pump is the one I retrofitted into my modified solvent tank.