To avoid these ads, REGISTER NOW!

Paying to have my electrical work done

CoogarXR

Well-known member
Joined
Jan 11, 2016
Messages
6,891
Location
Ohio
You know, I've been putting off my electrical project for almost 6 years now. Time to cut the ****, lol. When I bought the house, I was too cash-strapped to afford another project. Then I switched jobs and had the money, but no time. Isn't that how it always goes?

Backstory- I have a detached garage/shop with a dedicated 100A service. The former owner operated a wood shop out there. Problem is, because it's a second building on my lot, and it's not a residence, I pay commercial rates for electricity. So for only a garage door opener, a DVR and 4 cameras, and a handful of lights I pay $50 a month in electricity! That's on the months that I don't fire up any HVAC or tools out there! That's a huge ripoff around here.

So I've been wanting to connect the garage to my house panel. And I've done this at a previous house, and it wasn't too hard. But this house has a much longer run, the garage has finished walls, the basement in the house has a lot of obstacles. It's been about 20 years since I was in the electrical field, so I don't remember all the code rules, and I certainly don't know what has changed in the code since then either. I have a friend who is an electrician, and I mentioned the project to him, and asked if he could give me his opinion on how he'd do the job. I've worked with him before on jobs where he did the electrical and I did the data and CCTV systems, so I know he does good work. He lives nearby, and offered to stop by and have a look.

Well, we finally met up the other day. I had a certain dollar amount budgeted for me to do the job myself. To this seasoned pro, this job looked like a piece of cake. He said he already had another trench job to do nearby, and he could come by and do mine next week too. He quoted the whole job for right about what I ballparked the cost of doing the job myself! I started the day thinking I was just going to get some advise and continue to never have time to actually DO the job, but ended up giving the job to a qualified person for the same cost! Ahh, it's a big weight off my shoulders.

So I am pretty excited. After 6 years of hem-hawing, the job is finally getting done. I will still have 100A, it will just be fed from the house, and I will have my second 1" conduit for my data, CCTV, cable, etc (I will do the low-voltage wiring myself, he's just putting in the extra conduit). No more $50-minimum bills! No more flaky wi-fi! WOO-HOO! Did I mention that I am excited?!
 
Last edited:
To avoid these ads, REGISTER NOW!

theoldwizard1

Well-known member
Joined
Feb 22, 2011
Messages
43,514
Location
SE MI
I know he is a friend, but you still need to be an "informed" consumer.

Ask what kind of wire he is using from the house to the shop. If you are willing to "step down" to a 90A breaker in your main panel (you will never miss those 10A anyway) and use aluminum MHF cable, you might save a lot of money !
 
To avoid these ads, REGISTER NOW!

pattenp

Well-known member
Joined
Jun 4, 2008
Messages
10,175
Location
Virginia - USA
What size, number of conductors and type of wire is being used to supply 100A? I've seen to many "electricians" use the wrong wire for 100A feeders.
 
To avoid these ads, REGISTER NOW!
Top Bottom