You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
PBT 70960 Crank/Cam Seal Install/Remove Tool Kit
- Thread starter mtd240
- Start date
zruvalcaba
Well-known member
Where was this kit when I needed it on Friday. Just replaced my timing belt, drive belt, water pump, and thermostat on my daughter's 2004 Passat. Could have used this kit to replace the seals since they came with the kit I bought. In the end, they weren't leaking so I didn't replace them but since I was already down there...I would have done it if I had this kit. I'd like to know COO...
71Datsun510Wagon
Well-known member
I don't have that particular kit.
I have a Pro Point labelled kit from Princess Auto that is very similar and it wouldn't surprise me if the manufacturer was the same. Pro Point is the house brand for P.A.
www.princessauto.com/pal/en/Pullers-And-Bearing-Tools/20-pc-Crank-Seal-Remover-And-Installer-Kit/8354110.p
It worked awesome for my needs. I used it for camshaft and crankshaft seals on my wifes PT Cruiser. It made the job easier for me anyhow, I'm a weekend wrencher who plays with cars.
I believe it was made in Taiwan. Very nicely finished and good value to me.
Cheers!
Rob
I have a Pro Point labelled kit from Princess Auto that is very similar and it wouldn't surprise me if the manufacturer was the same. Pro Point is the house brand for P.A.
www.princessauto.com/pal/en/Pullers-And-Bearing-Tools/20-pc-Crank-Seal-Remover-And-Installer-Kit/8354110.p
It worked awesome for my needs. I used it for camshaft and crankshaft seals on my wifes PT Cruiser. It made the job easier for me anyhow, I'm a weekend wrencher who plays with cars.
I believe it was made in Taiwan. Very nicely finished and good value to me.
Cheers!
Rob
Last edited:
stonesfan68
Well-known member
Nice 70 bucks isnt too bad I guess. that PBT is uaually about 130ish. and Snap On charges I think 200 for it lol.
But can we get a COO on the PBT?
I have submitted a request for the COO. I'll report back.