Peddinghaus 22-10 Punch tool

[Brunow]

Everybody love's tools!

This is my new peddinghaus 22-10 punch tool.
I allready have a 20T shoppress but you can't use it as a metal cutter due the lack of allignment. Sure you can build stuff for it but hey.
I found some room for the little punch so...

Planning to make a little table around it for easy working.
Love this drill press table, just adjust it to fit the punch

The idea is to use my old stamps and adjust them to fit the machine.
Also planning on making a little louvre stamp.

Anyone else got a little punch tool?

 

[Brunow]

 

[Cypherian]

Nice ,

I did not know they made that , I know them for hammers and anvils. Here it is Pexto or Peck Stow , tennsmith , dries and krump , Chicago for older metal working machines.

Cypher

 

[Bottlecapdigger]

Everybody love's tools!

This is my new peddinghaus 22-10 punch tool.
I allready have a 20T shoppress but you can't use it as a metal cutter due the lack of allignment. Sure you can build stuff for it but hey.
I found some room for the little punch so...

Planning to make a little table around it for easy working.
Love this drill press table, just adjust it to fit the punch

The idea is to use my old stamps and adjust them to fit the machine.
Also planning on making a little louvre stamp.

Anyone else got a little punch tool?

I love working with my punch tool , I use it quite often. I only have round dies though, but most of the time that's all you need. I have the rotex 18A. Which have a rotating die plate and punch. It has 18 sizes from 5/32 up to 2". Check them out. They where made in California. I'd post a pick but I always have trouble getting this to work. BCD

 

[Brunow]

Whow nice punch! I do like this setup!

 

[Bottlecapdigger]

Yup thats the one. I don't have the table though. Got mine through another guy that got it at an industrial auction. You see them on eBay once in awhile. Used ones aren't less then 3-4000$. Depending on condition of the dies. Got mine for a lot less. Sure has been a handy machine in my shop. I seen that baileigh has one similar to yours in their catalogue BCD.

 

[Bottlecapdigger]

Also should mention they are rated I think for 8 ton. I've punched as much as 11 ga on some of the smaller holes. BCD.

 

[Bottlecapdigger]

Here's mine

 

[randydupree]

i have a 70 ton Peddinghause iron worker,its quite large!