Pegboard Springs - Where to buy them

[CalJJ]

Hi, I have been looking around the net for some springs to mount odd shaped tools on pegboard and have been striking out. I contacted a spring manufacturer and they wanted $1.90 a piece to make them, which would be fine if I only needed a handful but I want a few hundred. A friend gave me a few and said he has never been able to find them again either. They are pretty basic, with square hook ends to clip into the pegboard. They can stretch to about twice their size and are fairly stiff for how thin the wire is, they hold items very well. Stainless would be nice but at this point I'm not going to be picky.

Thanks, Jason

 

[bigbubba]

Did you check with these guys www.planetspring.com? They have a spring with the right end shown.

 

[CalJJ]

Thanks for the heads up, I'll give them a call and see what they have.

 

[CalJJ]

bigbubba, where on the site did you see the spring with the same ends? Were they bent outward from the coil center the same? I called them and was told to email a pic to another company, Acxesspring.com, still waiting on a reply. I have found some companies that will make them but they would cost $1.90 a piece!