GarageEnvy
Well-known member
After 10 years of dreaming and finally realizing that I'd never save the cash to do this I buckled and went to the bank to make it happen. Weather delays, product delivery days, some conflicting inspections from different inspectors and the inevitable delays from the county getting the initial approval were all part of a typical construction process but with the exception of a few details it is done.
Didn't really think to take photos of the old garage demo so the story starts with the cutting of the old slab where it attached to the house. My cutoff saw didn't get it done so I and my very helpful wife dilled holes every 3 inches. In the end the excavator broke the foundation wall anyway and I had to fabricate a 40' long truss to support the wall while we excavated the old foundation out from underneath. Ahh good times.
Bring on the concrete. 38 yards
The next day (yeah I questioned it hard but it worked out fine) it was bring on the framers
One day for wall framing, one half-day for trusses and 3 days to work the very tricky tie in to a 55 year old stick framed roof and two more days to redo the eaves and facia around the whole house (one of those unexpected "you might as well's"). I also changed the entry of the house. The old one was sagging, architecturally asymetrical and dumped water on a window and people coming up the walk.
New roof, new windows, new front walk, new front entry door, removal of bathroom skylight and a few more unexpected "you might as well's" later.
And some finish details. Thanks to Jack Olsen I discovered Strong Hold cabinets. Thanks to this forum and my wife, I was talked into an Epoxy Coat floor. There's a separate write-up on that. The photo of the step with the expanded stainless steel is pretty much for Jack. He graciously gave me some legs off his strong hold cabinets and I wanted to show him they did not go to waste.
Didn't really think to take photos of the old garage demo so the story starts with the cutting of the old slab where it attached to the house. My cutoff saw didn't get it done so I and my very helpful wife dilled holes every 3 inches. In the end the excavator broke the foundation wall anyway and I had to fabricate a 40' long truss to support the wall while we excavated the old foundation out from underneath. Ahh good times.
Bring on the concrete. 38 yards
The next day (yeah I questioned it hard but it worked out fine) it was bring on the framers
One day for wall framing, one half-day for trusses and 3 days to work the very tricky tie in to a 55 year old stick framed roof and two more days to redo the eaves and facia around the whole house (one of those unexpected "you might as well's"). I also changed the entry of the house. The old one was sagging, architecturally asymetrical and dumped water on a window and people coming up the walk.
New roof, new windows, new front walk, new front entry door, removal of bathroom skylight and a few more unexpected "you might as well's" later.
And some finish details. Thanks to Jack Olsen I discovered Strong Hold cabinets. Thanks to this forum and my wife, I was talked into an Epoxy Coat floor. There's a separate write-up on that. The photo of the step with the expanded stainless steel is pretty much for Jack. He graciously gave me some legs off his strong hold cabinets and I wanted to show him they did not go to waste.
Last edited: