phillips driver tips with 5/16 hex

[Steve_P]

does anyone make these? I have some old williams socket mounted phillips drivers that are worn, and also an older Taiwan impact driver which uses this size. The new williams replacement tips are the now common 1/4 hex.

I'm looking for something about an inch or so long and PH2 primarily but maybe also 1 and 3 if they're available. Thanks

 

[Monte]

Wiha. PH 2,3,4

http://www.wihatools.com/700seri/721_720serie.htm

 

[UK Steve]

Ko-ken manufacture 5/16" hex.....in Phillips, Pozi, Plain, Hex, Torx & XZN in various lengths. but I'm sure there are more manufacturers....

 

[Monte]

Wera for example

 

[UK Steve]

Well there you go.....

 

[Ed_EOD]

PB Swiss has them also.

http://pbtoolsus.thomasnet.com/category/c8-5-16-precision-bits

 

[Monte]

Apex + Geta probably offer them too

 

[rsanter]

snap on and craftsman have them

bob

 

[Steve_P]

Wiha. PH 2,3,4

http://www.wihatools.com/700seri/721_720serie.htm

Thanks! Will get some on my next Wiha order.