Pipe Anvil

[Rockable]

I made myself a poor man's radius brake yesterday, aka pipe anvil. I think it's going to come in really handy. The small pipe is bolted on, so I can have different small sizes.

 

[lilredex]

Good one! I made a similar version, here.

Sheet Metal Roller

Sheet Metal Roller: This sheet metal roller was made from materials that were on hand. I used a 3" pipe as it looked about the right diameter for most curves. The follower bar is a length of 1" pipe, the bar clamp on the rear is 1 X 3/8" bar as are the feet and the f…

www.instructables.com

 

[Mr.N]

Thank you Rockable and lilredex for both your post... I am now looking forward to make one!

I didn't event know these existed before this post.

 

[Rockable]

Thank you Rockable and lilredex for both your post... I am now looking forward to make one!

I didn't event know these existed before this post.

That's the reason I posted it. Good luck! I had this on my to do list for a long time and finally just did it.