toms73novass
Well-known member
I know that there are several woodworkers on this board. I have done woodworking for 20 years as a hobby and have acquired quite a few nice machines.
One of the items that I have always wanted but was way too expensive was a materials feeder for a table saw/router. This way if you are cutting thinner pieces or routing an edge on lots of material you get a nice consistant cut.
The problem is that they go for about 300-350 a piece, new and that is way out of the ballpark for the amount of woodworking I do.
Well I went to a garage sale today and low and behold there was not just one unit there but two. One used once and the other still with the original twist tie on the powerchord never used!
I ended up pickem' up for $140 for both!
They look like this:
One of the items that I have always wanted but was way too expensive was a materials feeder for a table saw/router. This way if you are cutting thinner pieces or routing an edge on lots of material you get a nice consistant cut.
The problem is that they go for about 300-350 a piece, new and that is way out of the ballpark for the amount of woodworking I do.
Well I went to a garage sale today and low and behold there was not just one unit there but two. One used once and the other still with the original twist tie on the powerchord never used!
I ended up pickem' up for $140 for both!
They look like this:
