Power probe 3 vs 4

[Altmech]

Hey guys looking to get a powerprobe but not sure whether I should go for the pp3 master kit http://www.amazon.com/gp/aw/d/B003Q...powerprobe&dpPl=1&dpID=51R23o3mlsL&ref=plSrch

Or just the 4

http://www.amazon.com/dp/B00NPY02EW/?tag=atomicindus08-20

I work on forklift and don't do a ton with fuel injectors and such so not sure if the 4 is really worth it. Is the extra stuff that comes in the pp3 kit worth it or is going with the plain pp4 a better option?

 

[Altmech]

Anyone have any suggestions

 

[toolman9w]

Something to think about. They will not repair a pp3 unless under warranty. I figure they will eventually phase them out.

 

[Bobioz1]

Why not get the pp3 without the master kit?

 

[Xxslyer1]

I have and use the pp3 master kit daily.(almost) I honestly had no idea a 4 was out, and I was on both Mac and snap on trucks today and they know I love my diagnostic equipment. So I'm partially shocked on my end but without checking the 4 out I can honestly say if you can't get it done with the 3, it's hard to get it done with anything else.

Edit:
I see this being a MAJOR improvement and way faster then setting up verus as far as injector faults, however it's a matter of what kind of work you do. Me personally I can see a use for this however won't get rid of my pp3 rather add this with the pp3. If you know what your doing injector mode can work for quite a few other diagnostic test without forking out extra on a scope. Soon as I get one(probably next week) il put her through some paces

 

[mikebramel]

I bought a PP4. Very nice tool. I made the mistake of selling my PP3. The extension leads for the PP4 cost asmuch as a PP3