Propress or Solder fittings?

[zmaxmotorsports]

''Ill upload a picture of the piping that will be getting torn out on Monday and be getting redone.''

It looks like they did not provide unions or flanges at new tank. Drains on piping should have been a typical install.

Basic install where they tried to cut corners and save a few bucks. Sure the pump has flanges, but when you disassemble flanges you're gonna get water all over.
It's these little things that PROFESSIONALS do that the cheap guys do not. They did do a nice job with the unistrut and clamps.

 

[danski0224]

''Ill upload a picture of the piping that will be getting torn out on Monday and be getting redone.''

It looks like they did not provide unions or flanges at new tank. Drains on piping should have been a typical install.

Basic install where they tried to cut corners and save a few bucks. Sure the pump has flanges, but when you disassemble flanges you're gonna get water all over.
It's these little things that PROFESSIONALS do that the cheap guys do not. They did do a nice job with the unistrut and clamps.

There's no isolation valves to allow servicing or replacement of components/strainers anywhere.

 

[danski0224]

Can you show me how to get a jet sweat around a corner inside of 90? Sometimes a piece of bread does wonders.

Someone makes a tool similar to the Jet Sweat with a flexible end and a squeeze handle to expand the plug.

 

[pl_silverado]

Which plumbing supply house? I buy a lot of stuff from ferguson and briggs,I don't remember seeing it.

Weinstein supply & Betz in the Philly area. I haven't bought it anywhere else, although I think I saw it at us supply last week.

Pm me your address and I'll send you a tub of it.