Punch and Chisel Holder

[dodge610]

I am probably going to order one today what is some of the better ones out there. Sears has the craftsman one on sale for $11.69 and $4.69 shipping. Leaning that way unless you guys have a better way to lean thanks for the help in advance.

 

[metaleltr]

A lot of people will use vise grips as Punch/chisel holder.

 

[Matt018]

A lot of people will use vise grips as Punch/chisel holder.

Awesome idea, I seriously never thought of that, thanks bro.

 

[metaleltr]

No problem. Everyone has a few tricks to share and what better place to do so!

 

[mark40sw]

I have the craftsman & a williams, williams is a little bigger & better.
from amazon
http://www.amazon.com/Snap--Industrial-Williams-28449-Chisel/dp/B005VMPP8E/ref=sr_1_2?ie=UTF8&qid=1332089469&sr=8-2

 

[wornoutoldman]

I have the craftsman & a williams, williams is a little bigger & better.
from amazon
http://www.amazon.com/Snap--Industrial-Williams-28449-Chisel/dp/B005VMPP8E/ref=sr_1_2?ie=UTF8&qid=1332089469&sr=8-2

That looks identical to the old school/vintage snap on tool

 

[wornoutoldman]

A lot of people will use vise grips as Punch/chisel holder.

A good smack on that will send a nice jolt up your arm.

 

[Fedwrench]

http://www.ebay.com/itm/Gearwrench-...&otn=5&po=LVI&ps=63&clkid=7096279108850926280

cripe has this Gearwrench version.

 

[DrkMtnDew]

Not the most economical choice but I'll throw it in anyway.

Snap On Holder

 

[PCO6]

I made mine.

 

[scott37300]

I just bought the craftsman one last week for 12 bucks in the store. I use it at work for holding letter stamps for marking parts I machine. So far it gets the job done. For the price its worth it over vise grips because its easier to hold.

 

[Hal]

A lot of people will use vise grips as Punch/chisel holder.

I have done this but don't like it. Sooner or later the Vise Grip jaws gouge up the shank of the punch or chisel, then I either slash my hand, or get steel slivers in it.

 

[archirelic]

Anymore custom punch & chisel holders out there? Or recommendations? Thus far, I haven't found many options which are suitable to me.

 

[Mr Ratchet]

http://www.ebay.com/itm/Gearwrench-...&otn=5&po=LVI&ps=63&clkid=7096279108850926280

cripe has this Gearwrench version.

That's the one that I have. It's a lot nicer than the CM one for about the same price.

 

[WhoWhatNow]

http://www.garagejournal.com/forum/showthread.php?t=53442&highlight=punch+holder

 

[Matt018]

Id still reccomend vise grips, They work fine.

 

[DARKSCOPE001]

I have the craftsman one. it tends to slide and loosen up a bit but its not bad for 12 bucks. not sure if they send that overseas yet but when i bought mine they still had plenty of USA made ones.