Quality Lifts

[Markgyver]

Does any one have any input on Quality Lifts I saw some at the local NSRA show the seem pretty nice, they look like a direct lift. They had a show price for around $3400 with a bridge jack. Also they guy said they are in the process of getting them certified.

http://www.qualitylifts.com/

 

[LWW]

Yeah, I'm not too keen on a "Sure! It's completely safe! We're working on getting them certified." My response would be "Hey, that's great! Call me when you've got your certification!"

 

[Spaggs]

I've got a Mohawk. I'm going to move and I'll be buying another Mohawk. I've had 16 years of great service with my first one. It is a little expensive, but I know I have a great product holding my vehicle while I crawl under it.

Spaggs

 

[JSK]

You can bet the quality of the product is good. Quality Lift is a division of Challenger Lift, a fine supplier. And if they said it was "certifiable" it most surely is. Getting through the ETL certification process takes time though. They most likely have done all the necessary testing, but are only waiting for the bureaucracy that is ETL.

$3400 + freight puts you in around $3800'ish? And that gets you a hand pump rolling jack correct? Sometimes those hand pump jacks are a PITA because you have to move the handle up and down - skinned knuckles usually results from banging on the underside of the vehicle, especially if low ground clearance.

BendPak has our 9K lifts and our air/hydraulic jack on promo until the end of this month. On promo, you could get our HD-9ST with air/hydraulic jack (OTC pump) for $3500.0 and that includes FREE SHIPPING.
Purchase from an out-of-state dealer and no sales tax.

Jeff
BendPak

 

[Markgyver]

Im not going to be purchasing a lift untill this fall. (Wife thinks its more important to pay bills first.) Anyway I will only buy a certified lift and have been looking into the bendpak quite a bit.

 

[Matt M PA]

JSK....I am planning on pulling the trigger tomorrow on a HD9....is there some "special" I should know about? Every little bid helps these days.

I beleive I also heard there will be a price increase (don't know if it's a Bend Pak or the dealers') starting on July 1st...so I'd prefer to get it done.

 

[JSK]

There is a Q2 promo going on until the end of June. Get your orders in quick.
Includes FREE shipping.

----------Normal / Promo
HD-9ST - 2595 / 2470
HD-9 - 2660 / 2530
HD-9STX - 2980 / 2835
HD-9XW - 3060 / 2910

CASTER KIT - 260 / 225
JACK PLATFORM - 185 / 160
DRIP TRAYS - 175 / 150
RJ-45 - 1210 / 1030


Jeff

 

[Matt M PA]

Thanks for the update JSK...ordering toooomorrow!