I've got my Dad's planer. Going to refurbish for the shop I'm building in my new house.
It's been in parts for years. Got the manual but missing a few parts which are no longer made or sold.
It is a model 113.206931.
All I'm missing are the Knob assembly parts for the fence.
Actually, 3 of the 5 can be purchased from the hardware store.
The fourth, the bolt retainer #21738, I could figure out and fabricate.
The fifth, a spacer, #47624, I don't know it's specs to fabricate.
I don't know if it forced the screw pressure to bear on the fence or the planer body.
If someone has an old Craftsman Jointer/Planner 113.206931 or 113.206801,
would you please disassemble and measure the length, outside diameter and inside diameter?
OR if someone has trashed theirs and going to use it for a boat anchor, please salvage this part?
Thank You,
Bob
It's been in parts for years. Got the manual but missing a few parts which are no longer made or sold.
It is a model 113.206931.
All I'm missing are the Knob assembly parts for the fence.
Actually, 3 of the 5 can be purchased from the hardware store.
The fourth, the bolt retainer #21738, I could figure out and fabricate.
The fifth, a spacer, #47624, I don't know it's specs to fabricate.
I don't know if it forced the screw pressure to bear on the fence or the planer body.
If someone has an old Craftsman Jointer/Planner 113.206931 or 113.206801,
would you please disassemble and measure the length, outside diameter and inside diameter?
OR if someone has trashed theirs and going to use it for a boat anchor, please salvage this part?
Thank You,
Bob