GrantOpus
Well-known member
I have a couple questions regarding a Legacy SD install I am about to do in our 3 car attached garage.
First question is how to go about removing the wall paint on the bottom 3-4” of the concrete in prep to get good adhesion of the primer/epoxy? The Mrs is wanting me to go in the wall 3” or so with the epoxy.
Second question is how many of you are stopping at the overhead door seal and who is going past the seal and doing the short apron on the outside of the garage door? I would like to go outside the door the 10” or so but had a bad experience with the polyurea coating I used on my detached building peeling.
Sent from my iPhone using Tapatalk
First question is how to go about removing the wall paint on the bottom 3-4” of the concrete in prep to get good adhesion of the primer/epoxy? The Mrs is wanting me to go in the wall 3” or so with the epoxy.
Second question is how many of you are stopping at the overhead door seal and who is going past the seal and doing the short apron on the outside of the garage door? I would like to go outside the door the 10” or so but had a bad experience with the polyurea coating I used on my detached building peeling.
Sent from my iPhone using Tapatalk
