Quick HF 13 drawer 44" tool box question

[newie]

Like many of you, I'm going to build a bench around one of these boxes. Mine is on back order due in next week. I'm going to use the casters for a different project that I'd like to start on today - does anyone have a loose set of casters from this box they could measure the mounting plate? Just need the overall dimensions in order to make mounting plates for the casters.

Thanks in advance!

Jon

 

[Jack Olsen]

EDIT: Wrong measurements.

 

[newie]

2-3/4"x3-5/8"

Thank you!

 

[csp]

Those dimensions are too small. I just used my old HF casters on another project and they are 3-7/8 x 4-1/2". I knew that 2-3/4" measurement was wrong as the legs on my project are 3" square and the mounting plates extend past the tube in both directions.

 

[Jack Olsen]

Wait. ****. I'm wrong. Sorry about that. I had a set in a box that I thought were from the HF box, but they're from something else. Hope that didn't mess you up.

Thanks for catching that, csp.

 

[hockey88fan]

Like many of you, I'm going to build a bench around one of these boxes. Mine is on back order due in next week. I'm going to use the casters for a different project that I'd like to start on today - does anyone have a loose set of casters from this box they could measure the mounting plate? Just need the overall dimensions in order to make mounting plates for the casters.

Thanks in advance!

Jon

I'd like to see the finished bench, sounds nice. The dimensions say 40" tall, is that with or without the casters?

 

[csp]

That's with them.

 

[hockey88fan]

That's with them.

Thanks!